1. Summary of revision
- Revision number
- Rev 2.24.01
- Reason for revision
- Fixing issue
2. Fixed issues
2.1 Setup and Execution
(1) Error occurred on DC parametric measurement
DC parametric measurement for the pin of any types except I/O caused an error.
- Behavior after improvement
- DC parametric measurement works properly.
- Revisions in which this phenomenon occurs
- Rev 2.24.00
- Target firmware
- CX1000_MCU, CX1000_MEMORY_TYPE_F
(2) Error occurred on timing setting
Error could occur on setting timing value around upper limit that had been able to set on the revision Rev 2.23.01 or earlier.
- Behavior after improvement
- The timing value can be set as same as on the revision Rev 2.23.01 or earlier.
- Revisions in which this phenomenon occurs
- Rev 2.24.00
- Target firmware
- CX1000_MCU, CX1000_MEMORY_TYPE_F
(3) Error occurred on specifying the address bit for the fail capture condition.
Error occurred on specifying the address bit for the fail capture condition.
- Behavior after improvement
- Error does not occur on specifying the address bit for the fail capture condition.
- Revisions in which this phenomenon occurs
- Rev 2.24.00
- Target firmware
- CX1000_MEMORY_TYPE_F