Reason for revision
Functional improvement
Functional improvement
Setup and Execution
Errors caused by DC parametric measurement conditions
Error occures when opening the work project or executing measurement under the following situation: - [Upper Limit] or [Lower Limit] in [MVM] mode are set the value with prefix (e.g. 100m, 10k.)
- Behavior after improvement
- In the condition above, they work properly.
- Revisions in which this phenomenon occurs
- Rev 2.20.00 to Rev 2.21.00
- Target firmware
- CX1000_MCU
Errors on specifying file path in measurement conditions
If the value which contained “\n” was specified for file path parameter, an error occurred.
- Behavior after improvement
- In the condition above, they work properly.
- Revisions in which this phenomenon occurs
- Rev 2.20.00 to Rev 2.21.00
- Target firmware
- CX1000_MCU, CX1000_MEMORY_TYPE_F
When clearing [Mask Pins] setting in pattern condition, previous setting remained.
When clearing [Mask Pins] setting in pattern condition, previous setting remained.
- Behavior after improvement
- In the condition above, it works properly.
- Revisions in which this phenomenon occurs
- Rev 2.10.00 to Rev 2.21.00
- Target firmware
- CX1000_MEMORY_TYPE_F
Work project
The setting for [Mask Pins] in pattern condition was saved in illegal format.
The setting for [Mask Pins] in pattern condition was saved in illegal format. However work project was loaded properly.
- Behavior after improvement
- It is saved in correct format. The work projects saved in illegal format at Rev 2.20.00 and Rev 2.21.00 can also be loaded.
- Revisions in which this phenomenon occurs
- Rev 2.20.00 to Rev 2.21.00
- Target firmware
- CX1000_MEMORY_TYPE_F
IP Manager
IP update did not work properly.
When there are no IPs to be installed, IP update did not work properly.
- Behavior after improvement
- In the condition above, it works properly.
- Revisions in which this phenomenon occurs
- Rev 2.20.00 to Rev 2.21.00
- Target firmware
- CX1000_MCU, CX1000_MEMORY_TYPE_F, CX50_GENERAL
Installer
The IPs were uninstalled when updating CloudTesting™ Lab
The IPs were unnecessarily uninstalled when CloudTesting™ Lab was updated. (They would be re-installed by IP Manager.)
- Behavior after improvement
- Uninstalling IPs is optional in installer. It will be applied for the update from this revision.
- Revisions in which this phenomenon occurs
- Rev 2.20.00 to Rev 2.21.00
- Target firmware
- CX1000_MCU, CX1000_MEMORY_TYPE_F, CX50_GENERAL