CTS CONT Cable(1.0m) is a cable to connect CX1000 and your measuring jig. This cable is included CW signal, PBVCC and I2C bus signal.
Required Cables
All GND/GND_S of CONT / FUNC connector on CloudTesting(TM) Station must be connected to the ground of your measuring jig, regardless of which measurement resource you use. If they are not connected, correct operation of this equipment is not guaranteed.
Required cables for each CloudTesting(TM) Station are bellow:
| CloudTesting™ Station | Cable |
|---|---|
| CX1000P |
|
| CX1000D |
|
| CX1000D S2-LINK Configuration |
|
Specifications
| Parameter | Value | Remark |
|---|---|---|
| Characteristic Impedance | Designed for 50ohm | |
| Capacitance | Less than 85pF | |
| DC resistance | Less than 0.5 ohm | |
| Usable temperature range | -55 °C to 85 °C | (Note 1) |
| Usable relative humidity range | 40% to 65% | (Note 1) |
| Lifetime of jig side connector | 500 cycles | Depending on condition. |
| Lifetime of CloudTesting(TM) Station side connector | 10,000 cycles | Depending on condition. |
| Manufacturer code of jig side connector | HIF3BB-50D-2.54C (receptacle [female]) (Note 2) | Manufacturer is HIROSE ELECTRIC |
(Note 1) Satisfy usable condition of CloudTesting(TM) Station at CloudTesting(TM) Station side of this cable.
(Note 2) This connector is a product complying to MIL standard (MIL-C-83503).
For details, please visit HIROSE ELECTRIC website. HIF3BB-50PA-2.54DSA(71) / HIF3BB-50PA-2.54DS(71) manufactured by HIROSE ELECTRIC are one of applicable pin headers.
