3. System Condition Monitor Tool

System Condition Monitor Tool

System Condition Monitor Tool is a analysis IP to check the configuration of CloudTesting™ Station.
After executing the measurement item on CloudTesting™ Lab, the measurement condition is set to CloudTesting™ Station and the measurement is started. There is a case to round the values of measurement condition by the resolution of CloudTesting™ Station.
In that case, the value in measurement condition and actual setting values are different. System Condition Monitor Tool displays the actual setting values which are set to CloudTesting™ Station.

Features

  • Displays the actual setting values which are set to CloudTesting™ Station
  • Can save the setting values as CSV file
  • Displays the following configurations
    • Power supply condition
    • Signal voltage condition
    • Signal timing condition
    • Pattern condition
    • DC Parametric measurement condition
    • AWG condition
    • DGT condition
    • RVS condition
    • DSRC condition
    • Sampling Clock condition
    • /CW condision
    • ATE Service UTILITY BOX condision

Add to Cart

Product GroupAnalysis IP
CodePCXT01-M6020
Link
ManufacturerADVANTEST CORPORATION
Applicable Equipment
  • CX1000P CX1000_MCU
  • CX1000D CX1000_MCU
  • CX1000D S2-LINK CX1000_MCU

Revisions

Released atNumberDescription
April 13, 20211.18.01
  • Fixed issues
    1. When using CloudTesting™ Lab Rev 2.43.00, System Condition Monitor Tool for Memory could not be opened.
      • Behavior after improvement
        In the condition above, System Condition Monitor Tool can be opened.
      • Revisions in which this phenomenon occurs
        Rev 1.18.00
April 01, 20211.18.00
  • Fixed issues
    1. When the power supply was connected in parallel, the CSV file was not opened correctly with Excel.
      • Behavior after improvement
        In the condition above, the CSV file is opened correctly.
      • Revisions in which this phenomenon occurs
        Rev 1.00.00 - 1.17.01
August 26, 20201.17.01
  • Fixed issues
    1. A comma was not inserted when the Mask setting was enabled in the Timing parameter check.
      • Behavior after improvement
        In the condition above, a comma is properly inserted.
      • Revisions in which this phenomenon occurs
        Rev 1.16.00 - 1.17.00
August 07, 20201.17.00

  • Addition of functions

    1. Supported for UTILITY BOX made by ATE Service(Supported only in Japan).
August 28, 20191.16.00

Supports Pin Multiplex function.

December 18, 20181.15.00

Add the function to display the empty character string when the edge of [Driver On], [Driver Off] and [Judge Timing] of Signal condition is not used.

March 18, 20161.14.00

Function to display the Initial State, DCLP, DCLM, Rise(N), Fall(N), Rise(P), Fall(P), Driver On and Driver Off of Signal condition.