1. Summary of revision
| Revision number | Reason for revision |
|---|---|
| 2.48.01 | Fixing issues |
Note
- Updating to this revision from a revision prior to Rev 2.47.00 requires the update for the following IPs.
- Measure Item Execution IP (PCXA01-M5008) Rev 1.02.00
- Shmoo Plot Tool (PCXT01-M6001) Rev 2.47.00
- Shmoo Algorithm (PCXT01-M6000) Rev 2.47.00
- Shmoo Plot Tool for Memory (PCXT01-M8001) Rev 2.47.00
- Logic Analyzer Tool (PCXT01-M6030) Rev 1.13.00
- Logic Analyzer Tool for Memory (PCXT01-M8004) Rev 1.10.03
- Waveform Viewer Tool (PCXT01-M7000) Rev 2.04.00
- Updating from Rev 2.44.01 or earlier to this revision requires the update for the following IP.
- CloudTesting™ Lab Expert Mode License (PCXS01-M0004) Rev 1.01.00 or later
CloudTesting™ Lab Expert Mode License Rev 1.01.00 Revision History - Work projects saved with this revision are not backward compatible with those saved with the revisin earlier than 2.44.00.
The revision of the CloudTesting(TM) Lab that opens work project must be 2.44.00 or later.
2. Fixed issues
2.1 Expert Mode
(1) Fixed the issue regarding the [Measurement Setting] tab of the DC Parametric Measure IP
| Target firmware | Revisions in which this phenomenon occurs |
|---|---|
| CX1000_MCU, CX1000_MEMORY_TYPE_F | 2.28.00 - 2.48.00 |
When another work project was opened with the following conditions, an inappropriate error message “Variable not defined” was displayed and the flow item area was not updated.
- Expert Mode
- The flow item for the DC Parametric Measure IP is selected.
- A variable is set to the measurement condition in the [Measurement Setting] tab of the DC Parametric Measure IP.
To continue the operation, the Main Window needed to be closed.
- Behavior after improvement
An inappropriate error does not occur when a work project is opened under the above conditions.