CloudTesting™ Lab 2.40.00

CloudTesting™ Lab Rev 2.40.00

1. Summary of revision

  • Revision number Rev 2.40.00
  • Reason for revision
    Addition of function, Functional improvement, Fixing issue
Notes on the update to Rev 2.40.00
When using the CX1000_MCU firmware, the firmware needs to be updated.
For details, refer to the "First Using After Installation" in the "User's Manual."

2. Addition of functions

2.1 Firmware

(1) Pin Multiplex is supported
Pin Multiplex is supported.
The new feature enables measurement over 100Mbps.

Target firmware
CX1000_MCU

For details, refer to “Setting Channels for Pin Multiplex” and “Setting Signal Conditions” in “Application Development” of “CX1000 User’s Manual.”

2.2 Pin definitions

(1) Function to search Pin Definitions
The function to search Pin Definitions is supported.

Target firmware
CX1000_MCU, CX1000_MEMORY_TYPE_F

For details, refer to “Defining Connections between Pins and Channels” in “CX1000 User’s Manual.”

3. Improved functions

3.1 Variables

(1) Two’s complement of hexadecimal is supported
Two’s complement of hexadecimal is supported.

Target firmware
CX1000_MCU, CX1000_MEMORY_TYPE_F

4. Fixed issues

4.1 Startup of CloudTesting™ Lab

(1) The error that notifies CX1000D S2-LINK with different firmware revisions did not occur
The error that notifies CX1000D S2-LINK with different firmware revisions did not occur.

Behavior after improvement
The error occurs for different firmware revisions.

Revisions in which this phenomenon occursTarget firmware
Rev 1.00.00 ~ Rev 2.34.00CX1000_MCU

4.2 Expert Mode

(1) In the setting of parameter for interpose algorithm Set Array Variable, variables could not be specified
In the setting of parameter for interpose algorithm Set Array Variable, variables could not be specified to elements of the String type array variable.

Behavior after improvement
Variables can be specified to elements of the String type array variable.

Revisions in which this phenomenon occursTarget firmware
Rev 2.20.00 ~ Rev 2.34.00CX1000_MCU, CX1000_MEMORY_TYPE_F

4.3 IP Manager

(1) Selecting IPs required to restart CloudTesting (TM) Lab under the Expert Mode license enabled
Selecting IPs from IP Manager under the Expert Mode license enabled, even if the Expert Mode license was enabled, a message indicating that the authentication status had been changed was displayed and CloudTesting™ Lab was required to restart.

Behavior after improvement
If the authentication status of the Expert Mode license is not changed, you can continue the operation without restarting CloudTesting™ Lab.

Revisions in which this phenomenon occursTarget firmware
Rev 2.20.00 ~ Rev 2.34.00CX1000_MCU, CX1000_MEMORY_TYPE_F